How do I set up RGB fans?

Where do I plug in the RGB for my fans?

Install the fans in your PC case, and screw it in the designated areas. 3. Use RGB Y-Cable to connect the fan and the motherboard. Please use RGB 4-Pin connector to an RGB header, and 4-pin fan connector to a fan header on the motherboard.

Can you connect RGB fans to power supply?

You will find one with a 6-pin connector on one end marked "Perif", and that plugs into the corresponding socket of the PSU. That cable has THREE female 4-pin Molex output connectors on it, and you should plug one of those into the power input connector of the fan controller in your case.

Do you need a controller for RGB fans?

The "Rainbow" 3-pin headers are Addressable RGB (ARGB) connectors. It looks like you're installing more than 8 lighting units and you only have two ARGB connectors and one RGB connector…so you need either splitters or a controller. A controller has additional power (SATA) to run several units.

How do I enable RGB fans on my PC?

To do this, remove the rear side panel from your chassis and locate the RGB/Fan controller. On the top side of the controller there is a switch, flip it (On the TURBO this controller is in the rear near the power extension cable). RGB in the system should now respond to the remote.

Related Posts

map Adblock
detector